Hi Nathan,
My 14-1/2" Gunner Barrel with the pinned and welded Flash Hider arrived today from AIM Surplus. As an added bonus it came with a Gas Block already drilled for a pin. It is already attached to the barrel with two set screws. I asked the folks at AIM how accurate was the gas block alligned before the drilled the hole for the pin. Their reply, was it was drilled by Faxon, not them. I inquired I didn't see any drilled gas blocks on the Faxon website, and their answer was they get some special things from Faxon not on the website, since they are just down the road from you.
My question is, do I need to be concerned in any way about the alignment of the gas block on my barrel? Do I need to measure and check things out when I remove the gas block to install my barrel nut? Or is everything good to go?
I now have a new Faxon gas block I ordered from you that I don't need.
Thanks,
Rick