Ramlines for anything should be used just for practice. If the ones you own have the rivet by the feed lip, they will work with the base plate off, because the follower contains the spring...sorta like a tape measurer. If they create problems, dont toss them out. I salvaged two stainless steel ones for a Browning 9MM by drilling out the rivet and adding a conventional follower, spring and base pad. The heat treat on these seems good, unlike the soft triple K, USA and Pro-mag after market brands. Anyway, the dirt can still get into the follower/spring assembly, after a time and I soak them in kerosene, working the follower up & down, then using air to dry them out. A coffee can of K-1, an old toothbrush and some rubber gloves...I even soak complete handguns, grips removed, this way too. All the crud settles to the bottom, leaving the kerosene clean. (may prefer a safety solvent if flammability is an issue) Sticker shock on real Sig mags?