I'm pretty bummed. This sight has been a safe queen, mounted on a couple different guns for less than 100 rounds. Now that I need it on my Tavor because of the extra high mounting options, it's acting up.

Are there any tricks or anything I can do to fix or reset it? I tried taking out the battery to let any capacitors on the board run dry, but it does the same thing when powered back up.

Thanks gents.

https://youtu.be/2HCRPBn6lQo

A couple of things to try-



- New battery. Long term storage with the battery in can cause the battery to run down. If the battery runs down, the dot will begin flickering or acting up in other ways.



- Tightening the battery cap a little harder. Sometimes the cap is not tight enough, making the connection less than adequate.



If none of those things fix it, please put in a call to our customer service department and they will get it in for a look. Their number is 800-426-0048 ext. 6



Thank you and please let me know if you have further questions. I would be happy to help.

I store stuff without a battery in it, because I've had too many electronics harmed or ruined from batteries going bad/leaking/corroding. The battery I put in it was unused, but I guess defective or didn't have a full charge.

A new battery seems to have fixed the issues. Same dot brightness as the other defective battery, but now it will turn on and off without flickering when the buttons are pushed.

Ok so now it's good to go? If anything ever comes up, please let us know. Thanks again!