Well I just got home from the ER. Piece of my 1911 removed from my hand Update in OP and morepage 5

[ARCHIVED THREAD] - Well I just got home from the ER. Piece of my 1911 removed from my hand Update in OP and morepage 5 (Page 1 of 6)

Posted: 6/29/2011 6:32:24 PM EDT

It's not what you think, and this should probably be titled how not to disassemble a1911.

This may take a while to type one handed.

I got my first 1911 after more than a dozen years of owning only glocks. Took it out to the range and it was flawless. Decided to detail strip and clean it today. My first time but how hard can it be right?

Tore it down to the frame and was using a punch to remove the pins. The second pin didn't budge so I cupped the frame in my left hand and pressed down with the punch with my right. It didn't budge so I really gave it a some pressure. POP. OUCH! that hurt like a SOB! I looked down and had a little round hole in the palm of my hand.

Well that sucked now where is my pin... I look all over and can't find it anywhere. Then I look at my hand again... There is a little raised spot in my palm about 1/2 inch from where the hole was. I gave it a squeeze. Ouch, Yep, There is my pin. My wife walked in and started freaking out about taking me to the ER. I was like wait, let me see if I can pull it out.

OUCH!

OK lets go.

The doc tried to dig it out for 15 minutes, he said he could see where it hit the bone.

Me "oh really is that why it hurst?"

Then he had to cut open my hand to finally get to it.

Tadaa

He was very worried about infection so I was given 4 pills and a shot before I left. But nothing for pain and it's starting to come unnumb.

So, anybody have a better way of disassembling a 1911?

I think I need a better method.

ETA. In response too all the how the heck is that even possible posts. Here is a pic of how I was holding it. Between the hammer not being lowered and a stupid hold on the frame, I was able to "Push" not shoot the pin into my hand.

As to all the questions of why tear it down in the first place? reason 1 was because I like to know how things work.
When I was about 6 my folks were eating at sizzlers and and looked around and I was gone. About that time the manager comes up with me in tow and said. Your son disassembled our drinking fountain and we can't figure out how to put it back together.

I've been that way my whole life and for the most part it serves me well.

reaosn number 2 is because I plan on replacing the trigger, beaver tail and Hammer so I needed to know how to take it down for that anyway.

I posted Follow up pics on Page 5.

Posted: 6/29/2011 6:33:01 PM EDT

[#1]

Glock thread?

EDIT: NO PAIN PILLS?

EDIT2: Is this how ZOMBIES start, fucking ironic.

Posted: 6/29/2011 6:33:45 PM EDT

[#2]

Fffffffffffffuuuuuuuuuuuuuuuu!

Posted: 6/29/2011 6:34:03 PM EDT

[#3]

In my 7 years as a member on this website (and the four I spent lurking before that), I must say this IS a first.

Posted: 6/29/2011 6:34:15 PM EDT

[#4]

What the.....how the........

Posted: 6/29/2011 6:34:35 PM EDT

[#5]

Quoted:

Glock thread?

No, if it had been a Glock they'd have had to amputate.
I keed, I keed

Posted: 6/29/2011 6:34:39 PM EDT

[#6]

I think this might be a first.

I wonder if the doctor still reported it as a gun wound?

Quoted:
In my 7 years as a member on this website (and the four I spent lurking before that), I must say this IS a first.

Yep...no shit!

OP, just EXACTLY what kind of a "punch" were you using to remove this USUALLY EASY to remove pin?

Posted: 6/29/2011 6:34:45 PM EDT

[#7]

At least you didn't lose the pin!

CHRIS

Posted: 6/29/2011 6:35:06 PM EDT

[#8]

This thread delivers

Posted: 6/29/2011 6:35:07 PM EDT

[#9]

Did you leave with the pin?

Posted: 6/29/2011 6:35:41 PM EDT

[#10]

How the fuck?

Posted: 6/29/2011 6:35:42 PM EDT

[#11]

Posted: 6/29/2011 6:36:28 PM EDT

[#12]

He gave you the pin back, right?

Posted: 6/29/2011 6:36:38 PM EDT

[#13]

damn glocks!!!!!!!!!!!!!!!!!!!

in on 1?

Posted: 6/29/2011 6:36:54 PM EDT

[#14]

How does this

stab somebody in the hand?

Posted: 6/29/2011 6:36:55 PM EDT

[#15]

JMB has exacted his vengeance upon you.

Posted: 6/29/2011 6:37:41 PM EDT

[#16]

It's OK. The pin is still good. Try not to get blood on your clothes.

Posted: 6/29/2011 6:37:53 PM EDT

[#17]

Yeah, I have to go with a WTF on this one.

Posted: 6/29/2011 6:38:12 PM EDT

[#18]

Ok, I figured it out.

The skin in the OP's hand is paper thin, unlike the rest of us.

Posted: 6/29/2011 6:38:32 PM EDT

[#19]

Please provide more information, including pics, on exactly what you did.

Hope you have a speedy recovery!

Posted: 6/29/2011 6:38:37 PM EDT

[#20]

Never heard of that. Wow dude, that sucks.

Posted: 6/29/2011 6:38:38 PM EDT

[#21]

you must become one with your weapon young grasshopper

Posted: 6/29/2011 6:38:57 PM EDT

[#22]

I would be soaking the crap out of that with warm soapy water on a constant basis until it healed up. You have serious potential for some bad juju there.

Did they force you into a tetanus shot?

Posted: 6/29/2011 6:39:16 PM EDT

[#23]

Quoted:

What the.....how the........

Exactly.

How hard were you pressing on the Mainspring Housing Pin?

Posted: 6/29/2011 6:39:19 PM EDT

[#24]

What. The. Fuck.

Did you finish cleaning it?

Posted: 6/29/2011 6:39:21 PM EDT

[#25]

I'm sorry but I had to laugh. I've seen a guy with a Barrett extractor in his leg that was blown out from using a suppressor, but this one takes the cake.
The whole pin in your hand?

Posted: 6/29/2011 6:39:26 PM EDT

[#26]

That pin is a dick. I take it out by standing a disposable chopstick on my coffee table, placing the gun over it with the chopstick pushed into the pin, and then shoving the gun down with body weight.

Posted: 6/29/2011 6:39:29 PM EDT

[#27]

Ummmm. I think your doing it wrong....

Glad you didn't lose the pin, no don't scratch the frame putting the slide release back in.

Posted: 6/29/2011 6:40:17 PM EDT

[#28]

You dont have a pet mouse, do you, Lenny?

Posted: 6/29/2011 6:40:39 PM EDT

[#29]

Get one of these

Bench block

Posted: 6/29/2011 6:40:39 PM EDT

[#30]

Well, its not every day you see something like this...

Posted: 6/29/2011 6:40:46 PM EDT

[#31]

According to the Brady campaign, you are now a "victim of gun violence".

And, seriously, you don't need to strip it down that far for a typical cleaning. Even if you did, that pin shouldn't require that much force to remove.

Posted: 6/29/2011 6:41:12 PM EDT

[#32]

LOL!

sorry

Posted: 6/29/2011 6:41:37 PM EDT

[#33]

Well... that's a new one on me.

Might I reccomend this and this.

Posted: 6/29/2011 6:42:04 PM EDT

[#34]

I'm no expert - but I think you're doing it wrong.

Posted: 6/29/2011 6:43:09 PM EDT

[#35]

Quoted:
Please provide more information, including pics, on exactly what you did.

Hope you have a speedy recovery!

I'll put in the same request. OP: more details, please. I'm trying to grasp how this could have happened.

The only mishap I've ever had cleaning my 1911 was when I sent the recoil spring plug flying right into the TV screen.

Posted: 6/29/2011 6:43:41 PM EDT

[#36]

Idiot scratch scar

Posted: 6/29/2011 6:43:59 PM EDT

[#37]

1911,,,they are so bad ass they can hurt you upon dis-assembly

Posted: 6/29/2011 6:44:27 PM EDT

[#38]

I think God is telling you that you should stick to Glocks...

Posted: 6/29/2011 6:44:37 PM EDT

[#39]

Shooting the pin with a .22 is not an acceptable way to remove it.

Posted: 6/29/2011 6:45:38 PM EDT

[#40]

I've heard of Garand thumb, but 1911 palm is probably going to be a limited use term.

You get extra points for trying, and coming through with pictures though. There is no doubt that it happened.

Here's to good healing...that's a bummer one there.

Posted: 6/29/2011 6:45:43 PM EDT

[#41]

You win the

"How the fuck did he do that!"

award for the day.

Also

Posted: 6/29/2011 6:45:46 PM EDT

[#42]

You need one of those nylon blocks with holes in it.

Posted: 6/29/2011 6:46:09 PM EDT

[#43]

if i had a "1911, you're doing it wrong" poster, i would be posting it.

Posted: 6/29/2011 6:46:11 PM EDT

[#44]

DAMN!!! Hope no infection sets in. What's up with no pain meds?!

Posted: 6/29/2011 6:46:19 PM EDT

[#45]

Posted: 6/29/2011 6:46:29 PM EDT

[#46]

You have accomplished a feat that I wouldn't have ever thought possible. Congratulations.

Posted: 6/29/2011 6:46:45 PM EDT

[#47]

Wow, thats a first, glad that was all that happened. I always laid mine on a role of electrical tape and put the pin in the center.

Posted: 6/29/2011 6:46:49 PM EDT

[#48]

Really soft hands + retard strength?

Posted: 6/29/2011 6:46:51 PM EDT

[#49]

OUCH!!!! Like others have said, HOW IN THE FUCK??? My recommendation to prevent this is to get a scrap piece of wood and drill a hole in it. Put the gun over said hole in wood and drive pin that way.

Posted: 6/29/2011 6:47:04 PM EDT

[#50]

shouldve stuck with the glocks. no tools required fr cleaning

[ARCHIVED THREAD] - Well I just got home from the ER. Piece of my 1911 removed from my hand Update in OP and morepage 5 (Page 1 of 6)

General » General Discussion

Warning

Confirm Action

About AR15.COM

Stay Connected

Newsletter

Contact Us