I read where the DMPS .308's come with a too- light buffer weight, and it was recommended to go to a heavier buffer, along with the compatible spring. I ordered the Car-10 buffer ( Brownell's part # 100-007-353) for my Oracle, which uses a carbine extension tube, and the modified spring ( part # 100-007-354) to go with the buffer. The heavier buffer weighs 5.5 ounces, compared to the stock buffer, which weighs 3.9 ounces, not much more than a 5.56mm weight, which goes 3.7 ounces. At the same time I thought I'd get a low profile adjustable gas block. There were several brands that looked Identical, teardrop shape with a brass set screw to lock the adjustment screw once you found your setting. I ordered one made by Doublestar, it was around $60.
Upon trying it out today, I expected to be able to get the AR to short stroke once I turned the gas down enough, then I would open it back up a turn. Problem was , I kept turning in the adjustment screw, and kept turning it in, and the carbine kept cycling, until I had turned the screw all the way in. It is all the way in, which should be cutting off all gas, turning it into a single shot. The carbine kept cycling the whole time, only difference noted, was right at the last few shots with the adjustment screw turned all the way in, the brass ejected to 4 o'clock instead of the normal 2 o'clock pattern. It doesn't seem like the new adjustable gas block is doing anything. At this point I guess I will take the gas block off, and try to see if the screw is actually closing. Perhaps there is something I can do, such as blowing compressed air through it to see if it is doing it's job. Any suggestions ?