Author
Message
TheAutarch
Offline
Posts: 3
Feedback: 0% (0)
Posted: 11/9/2006 2:55:29 PM EST
I finally got around to buying an AR. I got a RRA Elite A4. I haven't had time to go to the range yet, though. So I'm taking it apart and I'm fiddling with the bolt. Sorry if its been asked, I did a search but found nothing.

My question is: How far does the firing pin portrude out of the bolt? When I push the firing pin it pops out about a millimeter or two(at most) before it stops. I compare this to the firing pin in one of my revolvers (with the hammer dropped and the trigger held all the way back) and it seems that the AR's firing pin sticks out about half as much as the revolver.

I'm having trouble visualizing the AR firing pin setting off the primer, since it doesn't seem to stick out all that much.

So, is it just me, worrying over nothing since I don't have time to shoot it? Am I just confusing y'all? Any input would be appreciated.

p.s. I made my own sling, using the sticky posted in the Slings section...it was easy and it works great.
badazzar15
Member
Offline
Posts: 489
Feedback: 100% (345)
Link To This Post
Posted: 11/9/2006 3:12:13 PM EST
its fine, thats how all ar15s are.
XM17SBullpup
Offline
Posts: 690
Feedback: 0% (0)
Link To This Post
Posted: 11/9/2006 3:18:01 PM EST
You can get a Firing Pin Protrusion Gauge, which will help you measure it. But min. is .028 and max. is .036 Hope this helps you out. And if it's new, don't worry about it. You shouldn't have any wear issues until at least 5000 rds or so, at least thats been my experience.
TheAutarch
Offline
Posts: 4
Feedback: 0% (0)
Link To This Post
Posted: 11/9/2006 6:16:03 PM EST
Thanks. I'm just suprised at how little it actually protrudes.

I really need to make some time to get to the range....