Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login

Log In

A valid email is required.
Password is required.
Posted: 3/14/2001 9:22:19 PM EDT
I was going to have a Hogue free floating handguard put on my BM Shorty Carbine. I wanted to have it done but was afraid that removing the front sight assembly would scratch the finish when it was removed and replaced. I would like to know if this happens. I was afraid that Murphy's Law would take effect. I sent the handguard back and got 2 20 round mags.
Link Posted: 3/14/2001 9:41:02 PM EDT
[Last Edit: 3/14/2001 9:53:48 PM EDT by HANGFIRE]
I had one put on my 20" Colt and the gun guys did a good job. I don't have a brake or flash hider though. I really like mine and it is a must as I use a Tanner Sling. Protects the gas tube better as well. I got the grip to as it was a package deal.
Link Posted: 3/14/2001 10:01:31 PM EDT
I changed out the factory Rock River Arms handguards on my 16" upper with the Hogue freefloat tube. I was just careful when removing the front sight assembly, and it was fine. I've been extremely pleased with the Hogue grip and fore-end.
Link Posted: 3/14/2001 10:24:11 PM EDT
I have a Hogue grip too.I like it very much. The more I think about the Hogue free float tube the more I would like to get it. [smash]
Top Top