Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login

Log In

A valid email is required.
Password is required.
Site Notices
3/20/2017 5:03:23 PM
Posted: 7/3/2001 9:38:37 AM EDT
Does anyone know how to "neck down" a cartridge? My thought was a Magnum Research Desert Eagle with a 50AE neck to accept the .223 round. Any opinions on how powerful this would be? Another thought was a 50BMG with a sabot for the .223. Any opinions on this config. It would require fabricationg the barrel or sabots but I think it would be interesting. I just don't know if it is possible to neck down a cartridge at home or in the shop without some specail million dollar piece of equipment.
Link Posted: 7/3/2001 9:49:13 AM EDT
Link Posted: 7/3/2001 9:55:41 AM EDT
I remember seeing a necked down 50AE with a 10mm/.40 slug. it was hellaciously fast. A .223 is really narrow compared to the 50 case width. I guess is could be done but I don't think that you will gain any advantage in volume over the normal .223 case. It will have a shorter action though.
Link Posted: 7/3/2001 10:40:45 AM EDT
To “neck down” a cartridge you will need special custom sizing dies. To go from a .50 to a .223 you would need several sizing dies each one a little smaller then the other, since going from .50 to .223 is to large a step. By the way the .223 bullet is .224 not .223. Another thing, there is a point of diminishing returns when it comes to wildcatting, a cartridge can only be necked down by so much and a bullet can only be driven so fast, before things start getting really messed up. Like over a certain velocity a bullet will disintegrate upon leaving the muzzle, and worse yet if you neck down a large cartridge case too much it may increase the pressure to a dangerous level. Wildcatting is a hobby in and of itself and you really should have some special equipment like a strain gauge to measure chamber pressure and a chronograph, plus the special sizing dies you will need will have to be custom made the same as the chamber reamer that will be needed to make the barrel. So unless you really want to get into a new hobby and are willing to spend the time and money that will be needed I would suggest you just find another cartridge that has already been fully tested and works, either a factory round or even one of the wildcats that has already been developed by another wildcatted. If you are still interested in trying this then I wish you the best of luck and please get some professional advice on how to do this safely. I am not familiar with the 50AE round but I think you will find that trying to use a 50BMG case to fire a .224 bullet will not work out, even if you could find the sabots the pressure would probably be too high and you would be trying to push the bullet way to fast. And last if you want a very fast .224 pistol just get one of the single shots that are chambered for the .223 Rem or the 22-250. The 22-250 and the 220 Swift are the two fastest 22s that are available. And for your 50BMG project just get a 22-250 or one of the custom rifles like a lazeroni they produce some very high velocities. Sniper for Justice VINCE AUT MORIRE (Conquer or Die)
Link Posted: 7/3/2001 12:44:09 PM EDT
The purpose of this was to make a repeating semiauto handgun with alot of penetration. another thought was to use the 45 ACP cartridge.
Link Posted: 7/3/2001 1:09:29 PM EDT
I saw a .50 bmg necked down to .17 before.
Link Posted: 7/4/2001 12:22:44 PM EDT
Ya and Daisy made a Red Rider chambered for the .177x99 BMG? :)
Top Top