User Panel
User Panel
User Panel
USA
|
Posted: 5/8/2024 12:09:24 PM EDT
Might be a dumb question but I swapped out my rail on my DD upper and while reinstalling the gas block taper pin into the low pro gas block I was doing it pretty hard and made some gouges into the gas block. Is there any issues I should be aware of with that or the pin being installed to far into the hole?
|
|
|
MI, USA
|
Posted: 5/8/2024 12:14:37 PM EDT
[#1]
You are fine
|
|
|
|
Posted: 5/8/2024 12:16:51 PM EDT
[#2]
Taper pin? If so, the taper pin will only seat as far as the hole taper cut allows.
W/o pics, it's impossible to address the "gouges". |
|
|
|
USA
|
Posted: 5/8/2024 12:57:13 PM EDT
[Last Edit: BonesJons777]
[#3]
Yeah I believe DD uses taper pins. Picture added. I put some cerakote over it so it doesn’t rust
|
|
|
|
Posted: 5/8/2024 1:48:25 PM EDT
[#4]
Quote HistoryOriginally Posted By BonesJons777: Yeah I believe DD uses taper pins. Picture added. I put some cerakote over it so it doesn’t rust https://imageshack.com/i/po5CFIJoj Ugly, but a non issue. |
|
|
|
|
Posted: 5/8/2024 4:58:16 PM EDT
[#5]
|
|
|
|
AR15.COM is the world's largest firearm community and is a gathering place for firearm enthusiasts of all types.
From hunters and military members, to competition shooters and general firearm enthusiasts, we welcome anyone who values and respects the way of the firearm.
Subscribe to our monthly Newsletter to receive firearm news, product discounts from your favorite Industry Partners, and more.
Copyright © 1996-2024 AR15.COM LLC. All Rights Reserved.
Any use of this content without express written consent is prohibited.
AR15.Com reserves the right to overwrite or replace any affiliate, commercial, or monetizable links, posted by users, with our own.
Attached File