I see a few options when searching rivets from McMaster.
the two that would apply are: Low-Strength Plain C1006 Steel or 18-8 Stainless Steel
I'm guessing i want the plain C1006 steel. is this correct?
thanks caspian
Posted: 1/16/2006 7:45:53 AM EDT
[#1]
I've been ordering and using the 18-8 stainless steel revits, so I am not aware of the other revits mentioned.
Posted: 1/16/2006 7:47:09 AM EDT
[#2]
have you parkerized a receiver with stainless? i thought stainless didn't take to parkerization.
thanks caspian
Posted: 1/16/2006 7:52:46 AM EDT
[#3]
I haven't parkerized any of my receivers. I basically been using Dupli-Color high temp engine paint to refinish my rifles. The finish has been wearing off on the high spots, but hey, it adds character to each of the rifles.