Quote History Quoted:
Purchased 500 rounds of the Malaysian from aim.
It will chamber and fire, I got about 4" groups from 100 yards out of my PA10.
ISSUE: Ammo fails to eject about 95% of the time. It will extract from the chamber, but then it gets caught in the extractor and does not leave the receiver.
The gun functioned flawlessly with off the shelf hunting ammo. I tired multiple mags, Magpuls, and steel mags. Always had the same issue.
Rim issues on ammo?
View Quote
I haven't taken my bolt(s) apart yet, but there is at least one youtube vid, and some discussion I read, that the two springs (inner/outer) under the extractor can cause it to 'run too tight' and the extractor wont let go of the brass at the right time, which can cause it to hang inside the receiver.
This is about general issues with ejecting, not specifically any particular ammo, but as stated above - it could be the Malaysian is just out of spec enough that it's one of the few times the stars align.
I'm not an expert in these things, these are my first two, I'm just passing on what I saw when people were discussing this same issue.
It might cause the issue, it might be coincidental, but it's one more thing to explore trying to figure out what might be
causing the issues.
I haven't had my extractor(s) out to look, because that bastage is held in by the pin(s) that won't move no matter what, and I'm not going to screw with it overmuch yet as mine are running fine.
So far.