My question would be why would someone want a bull barrell turned down when they could buy a slimmer profile and install it? Wouldn't it cost about the same or maybe a little less? I'm just guessing here as I've never had it done. Take care.
|
Because, in case you haven't looked lately, there aren't exactly a whole flaming lotta choices in barrel profiles out there! There's HBAR, then there's "M4". Anything else is pretty much a custom job.
I wanted a mid-length barrel with the A2 contour, so I went with ADCO. I also had an HBAR turned and fluted by KKF, and the work was well above satisfactory...
I would not hesitate to use either.
As far as results, both were noticeably lighter than the original HBAR, with the "A2" being the lighter of the two of course.
I'm glad I did it, and I'll do it again if I can't get the profile I want "off the shelf".