I just decided to go with one and at 5.5 ounces Im hoping it will some what slow down the unlocking of the bolt until chamber pressure is lower than what it would normalybe as the bolt/carrier starts its extraction.Am I correct in assuming this? will it also lessen what little recoil there already is? what other benefits are there?I would hope it will lessen its harder running than rifle tendencyThanks..927
Posted: 8/2/2005 9:12:52 PM EDT
[#1]
I have one for your primary reason, slowing down extraction.
Posted: 8/3/2005 4:37:01 AM EDT
[#2]
A 9mm buffer is not needed for a carbine length gas system. Some people prefer them over the standard carbine buffer but it's not necessary for the rifle to run reliably.
I tried one on my carbine and didn't like. The recoil was not as sharp but the extra weight made the recoil seem heavier (which makes sense). Also, the extra weight can cause (depending on the rifles configuration) the balance of the rifle to shift slightly to the rear when the action cycles.
If I ever decide I want to try a heavier buffer, I will try an H buffer. It only weighs .87 oz more than a standard carbine buffer.
Posted: 8/3/2005 4:39:03 AM EDT
[#3]
Argh. Double tap.
Posted: 8/3/2005 7:03:27 AM EDT
[#4]
i have a mgi rrb in my carbines and it weighs ~7oz. and i have close to zero muzzle rise.
slows down tha action greatly!.
Posted: 8/3/2005 7:16:30 AM EDT
[#5]
Quoted: i have a mgi rrb in my carbines and it weighs ~7oz. and i have close to zero muzzle rise.
slows down tha action greatly!.
But is it really fair to compare that $150 mechanical buffer to a $25 buffer? I'm not disagreeing with you but I want to make sure we're comparing apples to apples.
Posted: 8/3/2005 7:20:17 AM EDT
[#6]
Quoted:
Quoted: i have a mgi rrb in my carbines and it weighs ~7oz. and i have close to zero muzzle rise.
slows down tha action greatly!.
But is it really fair to compare that $150 mechanical buffer to a $25 buffer? I'm not disagreeing with you but I want to make sure we're comparing apples to apples.
well, in that case i have used the h-buffer and the h2 buffer in my carbines and if you pay reall good attention you'll notice the slight difference.
imho not enough to notice but enough to slow it down a tad.
Posted: 8/3/2005 9:15:12 AM EDT
[#7]
IIRc, the issue M-4 uses an H buffer, correct?
Posted: 8/3/2005 9:16:47 AM EDT
[#8]
I know we have beat this to death in the past few months, but I'll add that I run a heavy buffer in one of my carbines, and the felt recoil is that of a gentle push. The difference is quite evident, and I do not feel more muzzle rise.
Posted: 8/3/2005 8:11:26 PM EDT
[#9]
Thanks for the input fellas.Im curious to see what it feels like as I havent shot it yet with the heavier buffer.
Posted: 8/4/2005 4:04:58 AM EDT
[#10]
Quoted: IIRc, the issue M-4 uses an H buffer, correct?