I was putting together a recent build, using one of your LBK, and noticed that the rear takedown pin has no groove for the detent.  Is this normal, or did my pin miss a step in the machining process?

It seems to work fine, but I'm a bit concerned about it drifting out without the groove to engage the detent and hold it in place.

Other than that, the quality of the LBK is superb, as always.

pretty sure that is not normal.

Not normal, there is supposed to be a groove with a dimple in each end of the groove where the detent "clicks" into place.

PSA will make it right, they're good for it.

Ok, I'll shoot them an email.

I kinda figured it was a mistake somewhere in the process, but figured I'd ask before I made a fuss.

I'm aware that PSA uses parts from various sources; side by side, the parts from various kits are usually quite a bit different.  As long as they work, though, and are of reasonably good quality, no complaints here...I just wasn't sure if some manufacturers don't groove their pins, for whatever reason.

We will have a replacement pin sent out ASAP. Can you please send us an IM with your order number?

IM sent, thanks.