A few months ago I noticed my brass chambering tighter. I adjusted my cam over according to lee's
directions which kinda fixed or at least improved the chambering. I bought a Hornady case gauge recently
and noticed I have fixed most of the brass but a few I noticed have the case head slightly stick out of the gauge.
I watched a video on cam over and it's possible that I wasn't adjusting enough. Even with adjusting the cam over more aggressive but
not too tight, it didn't improve the seating in the gauge. However, these cases that fail the gauge
chamber like butter. Is this anything that I should be concerned with as these cases only have been fired a
few times and never to max. Just not sure what I can do to get these cases to pass. I normally neck sized until I had this issue. This is with Hornady brass.