[ARCHIVED THREAD] - GSG-5 PK -- Barrel Threads

Posted: 4/30/2009 6:03:53 AM EDT

What is the thread pitch of the gsg barrel? Is there an adapter out there for running a 1/2 x 28 can? Thanks.

Posted: 4/30/2009 7:01:47 AM EDT

[#1]

Check with swarfworks.com They make two versions for the PK.

I've got both. Below is a picture of the 3 lug. It is threaded 1/4 28 on the end with a thread protector in place. The other is just an adapter/protector. IMO the 3 lug looks fantastic on the gun without the can (much better then the stock flas suppressor). The shorter one looks better with the can. So I bought both. Nice workmanship in these units and they shipped very quickly.

Posted: 4/30/2009 9:45:02 AM EDT

[#2]

With a bit of dremel polishing, any of the thread adapters for the Sig Mosquito pistols will work - same thread pitch.

Posted: 4/30/2009 11:00:02 AM EDT

[#3]

The threads are the same but is it long enough to allow the silencer to mount correctly? I understood they were too short and allowed the silencer to bottom out on the sight post and not the shoulder.

Posted: 4/30/2009 12:34:06 PM EDT

[#4]

the tech spec on the threads is M9 X .75 if that helps you out.

Posted: 4/30/2009 4:26:13 PM EDT

[#5]

i just went to swarfworks.com and order one

Posted: 4/30/2009 4:46:49 PM EDT

[#6]

Julio at mygsg5.com has two options as well, both with 1/2x28 tpi threading for .22 cans.

Posted: 5/1/2009 7:01:59 AM EDT

[#7]

Ordered the threaded end from:

www.mygsg5.com

That way I can put whatever flash hider on the end I desire.

Posted: 5/1/2009 9:56:52 AM EDT

[#8]

I picked up one from swarfworks.com. The PK looks really nice with them on and you can add you choice of suppressor. But the nicest thing is that it is just long enough to keep you thumb from getting close to the muzzle.

[ARCHIVED THREAD] - GSG-5 PK -- Barrel Threads

Armory Sponsor

Warning

Confirm Action

[ARCHIVED THREAD] - GSG-5 PK -- Barrel Threads

[ARCHIVED THREAD] - GSG-5 PK -- Barrel Threads