Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Page AK-47 » Chinese
Posted: 12/4/2005 2:06:31 PM EDT
[Last Edit: 12/4/2005 2:06:48 PM EDT by Belial]
Done one???

How did you get the front sight base pins out??


I was gonna get out the drill press but I would bet the pins are pretty hard....



cheers
Link Posted: 12/6/2005 4:44:16 AM EDT
I drilled them out. I had extra pins to replace them. My punch that was the correct size to kept bending as the pins would not move. They are supposed to just punch out.

Link Posted: 12/6/2005 10:31:08 PM EDT
How can you just punch them out when they are put in a hole?? As in they do not go all the way through from one side to the other. These pins do not go through the front sight base on the Polytech Barrels I have seen...

I was thinking about drilling the other side but it will never line up again and I will have the holes to weld up and refin...
Link Posted: 12/14/2005 12:31:08 PM EDT
Nobody has a good fix for this one?!?!
Page AK-47 » Chinese
Top Top