Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Posted: 6/23/2003 10:00:58 AM EDT
[Last Edit: 6/23/2003 10:09:15 AM EDT by MPi-K]
Going thru my AK stuff, I found this cleaning kit I bought in the early 90's. Figured I'd post a pic of it to see if any of you AK's guru's could help me id it.

From left to right:
Parkerized steel hinged case with a tension spring inside to keep the parts from rattling.
Cleaning tip with a slot cut in it, fits my AK cleaning rods just fine.
Non-tapered punch that is the same diameter as a AK axis pin.
Tapered Punch.
Some kind of combination tool.
Gas port cleaner - doesn't fit any of my AK's.
Gas chamber reamer w/ a sleeve that fits over the end of it - again to big for any of the AK's I've run across.
7.62 X 39mm ruptured case extractor, very well made.

None of the parts are marked in any way. Is this some kind of RPD kit?


Link Posted: 6/23/2003 2:31:41 PM EDT
Link Posted: 6/23/2003 5:16:29 PM EDT
Well Campy, I'm not sure its for an AK, I thought at first it was a RPK kit, after I ruled out the RPK, I assumed it might be for a RPD.
I bought it in the early 90's at the big Astrohall gun show they have in Houston. There used to be this foreign fellow who had a table always at the very back of the show. He had all kinds of rare Warsaw Pact parts and misc, mostly E. German stuff. He had quite a few of these kits and told me they were East German. I bought it mainly for the 7.62 x 39mm ruptured case extractor. The non-tapered punch is handy for assemmbly of FCG's on stamped AK recievers.

Top Top