Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
Posted: 12/19/2002 10:20:06 PM EDT
i recently got a GREAT deal on a ak project from DROCK...( so great that i still gotta pay him : ) ).... it's a polish kit ..looks absolutely nib that he had the barrel and all the work done to a ohio ordnance receiver..just waitin on santa to bring my rsa fcg for my krink and then the gordon tech fcg goes in the polish kit.. i want/need a template for the underfolder cut out and maybe some advice on how to cut/drill the receiver . it currently has a fixed stock rear trunnion but he gave me the complete underfolder kit and i want to install the correct trunnion to LEGALLY INSTALL the underfolder in the FIXED OPEN POSITION. the gun will have ...(3) US fcg parts...(1)US p/g... (1) has US gas piston (1) US receiver (1) US made slant brake pressed on.. so i SHOULD be ok on the parts count right? any and all help GREATLY appreciated
john in houston
Link Posted: 12/20/2002 3:23:10 AM EDT
Link Posted: 12/20/2002 2:11:56 PM EDT
thanx for any help /advice you can give... looking at it ..i can see how it has to happen.. i was just hoping a person who had "been there done that " could infuse me with his/her wisdom..... i can see a cheapo and easy way to do it by just drilling a couple holes where the lugs on the latch lock in the trunnion.. but in the event the ban actually sunsets i was gonna pin with a spot of weld the latch.. so that with some effort it could be made to work as it was intended.... also other than my krink.. drock has helped me acquire my very 1st "new ak".. i have a coup;e ..they run great.. but they were popped by someone other than me.. so i am kinda excited about havin a ak that is new
john
ps thanx campy for the reply..anything you can do i look forward to
Link Posted: 12/21/2002 4:20:24 AM EDT
Link Posted: 12/22/2002 2:36:23 AM EDT
thanx campy .. appreciate the effort
john
Top Top