AR Sponsor
Posted: 8/6/2005 2:47:25 PM EDT
| After taking the advice of every one on this board I coughed up the bucks for a dewey cleaning rod, .22 cal and an extra .22 jag. HTF do you guys get the darn thing through the barrel with a patch on it. Seems way to tight to force. I have .22 cal specific patches, several brands but don't feel comfortable useing the force necessary to push them through. What gives. |
| IT is supposed to be tight and that is one reason you want a solid rid like a Dewy to take the pressure. Mine are extreemly tight and some time I have to hammer it through by hitting it with my palm. Keep working on it and you will get the feel for it. Do try to cut down your patches a littl but if they ar .22 patches you should not have to. |
|
Note that it is fairly easy to get an overly tight patch stuck in an AR chamber (been there, done that!). First, be sure and put some solvent or CLP on the patch to get the bore wet. It can be really hard to get a dry patch through a dry, dirty bore. Still, patches can vary a bit in thickness. If you need to, snip a small slice off the patch with a pair of scissors. Personally, I don’t like a super tight patch since it can cause the cleaning rod to flex and rub against the bore (and you didn’t mention getting a rod guide!). |
|
Step 1: Go to wal-mart Step 2: Get out of car Step 3: walk across parking lot twords the store Step 4: go into the door Step 5: walk to the the sporting goods section Step 6: look for a .17 cal 1 peace ruber coated cleaning rod Step 7: walk over to the desk in the sporting good section Step 8: ring the little stainless steal bell Step 9: when the guy come over pay 4-8 dollars for the rod Step 10: leave the store walk across parking lot get in car and drive home take the peace of craborad off the rod handle put patch down the barrel and clean. For best results rinse and repeat. |
wow, that was a lot of typing to give a simple jack-ass response. |
Look i put alot of thought into being a asshole this kind of thing doesn't come over night it takes years of exp and alot of typeing to be the perfect asshole and i take pride in my part in society. |
|
I had the problem with exact same setup (assuming you are using Parker-Hale style jag). Here is what I was doing wrong: Wrong way: Taking patch and draping all the way around the end of jag (i.e. acting as though I was stabbing the patch with the jag - the tip was covered with the patch)....This resulted in stuck jag and lot's of cussing due to new Dewey rod being bent. Right way: Take patch and roll it around sides of jag, not the very front. In other words, roll it like you are rolling up a cigarette. Don't stab the patch. This will result in a firm but not overly tight patch. One other thing, all the brass will not be covered with the patch. That's OK as the exposed brass will never touch the barrel due to patch being wrapped around the other portion of the jag. |
AR Sponsor