AR Sponsor
Posted: 8/15/2007 1:30:09 PM EDT
|
Help! One of the set screws on my gas block is so tight that it is actually twisting my allen wrenches! It would have been done at DPMS and I guess they put permanent Loc-tite on it. Does anyone know how to get this screw out? Is there something that will dissolve the loc-tite? I don't even know if that was used? Any suggestions would be greatly appreciated! Mark |
| i have had to use heat. i bought a cheap butane pencil torch at harbor freight. you can pinpoint the heat with the small torch. can you see the color of the lock tite.red or green is very tough . make sure you have got a good allen wrench that fits correct if you round it out you will be drilling it out. |
AR Sponsor