OK so I have it built.
It works like a champ but now I need to sight it in.
I have read all the stuff about Battlefield sighting at 300 but heres the question.
It is an 8/3 sight
When I bottom out the elevation it is two cllicks below 300
I will be using a 50 yard range for this
Where do I start to sight in from?
one click up from absolute bottom
two clicks up from absolute bottom which is 300
And where do I hit the target?
Where my aim point is
1.25" lower than my aim point
Any help is greatly appreciated.
Thanks Guys and Gals
Here is link where you can print off your own targets for zeroing. There are instructions on the bottom of them.
Good luck and welcome to the board.
Cool just what I was looking for.
Imagine that, search does work.
At two clicks below 300, you have your rear sight set for the Improved Battlesight Zero (IBZ). All you need to do from there is adjust the front sight for elevation and the rear for windage in order to hit the point of aim at 50 yards. This produces a flatter trajectory with point-blank at 50 and 200 yards. When the range is known to be 300 or greater, set the rear elevation accordingly. Sighting in is done with the small aperture.