Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Posted: 8/18/2003 11:07:12 AM EDT
How do I remove the pressed on M4gery flash hider from my Rockriver Entry Tactical? I need to install a railed forearms and need to remove the front sight and flash hider to do it. I'm a machinist and can easily make a puller if that's all it takes. Also, I'm new to this board and the AR world. I have a couple 50 BMG's and spent time on the Biggerhammer Board. Hope to spend time here soaking up the info. Dave C.
Link Posted: 8/18/2003 11:19:35 AM EDT
The RRA false brake is easily removed by tapping forward with a hammer using non marring block.
Link Posted: 8/20/2003 6:26:09 AM EDT
Last night I made a puller and removed the flash hider. Rockriver nurls a spline on the barrel to hold the pressed flash hider in place. Just in case someone cared. Dave C.
Link Posted: 8/20/2003 6:33:54 AM EDT
Put the barrel in the freezer for an hour, remove it and warm up the fake flash suppressor with a propane torch (just warm, don't get it hot enough to damage the finish). Use a block of wood and a mallet and it should come off.
Top Top