Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Posted: 10/17/2003 8:19:57 AM EDT
I recently purchased a TA-31A and #19S mount. Eventually, I want to add a #40 BUIS and a RAS-II to the mix, but wondered if everything would fit. Can you mount the TA-31A/#19S and #40 with the RAS-II mounted?

Thanks!
Link Posted: 10/17/2003 9:00:58 AM EDT
Should work perfectly.
Link Posted: 10/17/2003 9:34:11 AM EDT
Yes, you'll use up the entire top receiver rail but you can do that combo.
Link Posted: 10/18/2003 2:37:41 AM EDT
Originally Posted By kfeltenberger: TA-31A/#19S and #40 with the RAS-II mounted?
View Quote
Splendid, truly splendid!
Link Posted: 10/25/2003 3:36:15 PM EDT
Thanks!
Link Posted: 10/25/2003 11:35:24 PM EDT
can anybody tell me how hard or easy to install a RAS II on a RRA upper with the pressed-on break?
Link Posted: 10/25/2003 11:42:29 PM EDT
If you can take off your standard handguards and use a screwdriver, you're g2g.
Link Posted: 10/26/2003 10:11:07 AM EDT
Excellent solid setup, and you have two positions for where to mount the 19S.
Link Posted: 10/26/2003 10:39:23 AM EDT
Originally Posted By AR223: Excellent solid setup, and you have two positions for where to mount the 19S.
View Quote
is the rail on the rear part of the RASII long enough to accomodate the 19S? [img]http://www.eaglefirearms.net/images/KAC%20images/KACRASIIFF.jpg[/img]I plan to do this same setup, but with a compact ACOG more then likely. I was warned about the ACOG not being mounted high enough on the standard flat top so if the 19S will mount on the RASII rail it would be all good.
Link Posted: 10/26/2003 11:07:07 AM EDT
I don't think you want to mount the ACOG/19S on the RAS II rail/hump since you're not going to be able to use the eye relief.
Link Posted: 10/26/2003 2:51:34 PM EDT
Originally Posted By Lumpy196: If you can take off your standard handguards and use a screwdriver, you're g2g.
View Quote
do I have to remove the barrel from the receiver?
Link Posted: 10/26/2003 3:05:44 PM EDT
[Last Edit: 10/26/2003 3:07:05 PM EDT by Lumpy196]
no, it has a top and a bottom portion. No need to remove anything other than the plastic handguards.
Top Top