AR Sponsor
Posted: 8/3/2007 5:42:53 PM EDT
|
Just bought a new Magpul PRS stock to place on my .223 RRA varmit rifle. Does anyone have a good website or source for step by step directions on the installation of the stock. It seems relatively easy based on the normal removal/ replacement of an A2 stock, but I just don't want to screw up anything. help Shawn |
|
Just unscrew the bolt on the back of the stock you have now (it threads through the butt plate and into the buffer tube) Pull the old stock back and off the buffer tube. Now just take the PRS and slide it over the buffer tube and put that screw back in and tighten it down just like the other one was attached. Just don't cross the threads on that stock screw and there's really nothing to mess up. -Mike |
|
Well actually you do. The spring that holds the detent for the take down pin will fly out at you when you remove the old stock. Be careful with that one. If you are behind the rifle, it will be on the right hand side at the bottom. After you unscrew the stock screw, pull the stock out, slowly and the the spirng will stay where it is. Put the PRS on the buffer tube and slowly push it forward, making sure you capture the spring and you compress it properly. Once that is done, screw in the big screw slowly making sure everything stays put. |
AR Sponsor