Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Posted: 11/10/2003 1:22:20 PM EDT
Hello folks.

What is needed to replace A2 stock with A1 length stock? I like the A2 stock over A1 stock in terms of the material used but I figure it is a bit long for me to shoot especially while shooting in prone.

Do I just need to buy the stock? Do I also need to replace the whole buffer tube and etc?
Link Posted: 11/10/2003 1:46:22 PM EDT
You just need to remove the A2 stock along with the spacer that goes onto the buffer tube, then install the A1 stock. I think you may need a new shorter buttstock screw as well.
Link Posted: 11/10/2003 2:15:34 PM EDT
Get the CavArms C-1 stock from [url=ar15.com/forums/topic.html?b=7&f=22&f=165879]Adrenaline_Arms[/url] on the EE! It will come with the needed hardware.
Link Posted: 11/10/2003 8:59:14 PM EDT
Originally Posted By notack: Get the CavArms C-1 stock from [url=ar15.com/forums/topic.html?b=7&f=22&f=165879]Adrenaline_Arms[/url] on the EE! It will come with the needed hardware.
View Quote
That stock rocks! It's so much better than the M16 surplus A1 stocks.
Link Posted: 11/11/2003 2:27:29 AM EDT
The M16A2 stock screw is 5/8" longer than the earlier screw, so you'll need to cut 5/8" off or the screw will impale itself on the tip of the buffer. -- Chuck
Link Posted: 11/11/2003 6:56:43 AM EDT
MaverickMkii: Are you in luck, dude! I'm selling a NICE A1 length stock that I purchased from CMMG (handpicked,no less), with an A2 buttplate assembly. I'm selling it cuz I just bought a VLTOR stock. I'm also selling a GGG single point plate adapter, so you can use the Wilderness Single Point Sling (just like the High Seed Boyz). Check it out: [url]http://www.ar15.com/forums/topic.html?b=7&f=22&t=184776[/url]
Top Top