Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login

Site Notices
11/20/2019 5:07:11 PM
Posted: 10/26/2004 12:29:17 PM EST
Is it possible to put a 80 series slide on a 70 series frame? If so, what kind modification is neccesary to make it work?
Link Posted: 10/26/2004 12:53:04 PM EST
[Last Edit: 10/26/2004 12:58:49 PM EST by MT_Pockets]
Link Posted: 11/1/2004 8:45:52 AM EST
70 slide on a 80 frame= Remove the firing pin plunger and spring (will be a small hole were the plunger used to be.

80 frame on a 70 slide = Remove the trigger lift/Firing pin plunger cams, and replace them with a single spacer ($6.00 from brownell's).

80 complete pistol for target use= remove the firing pin plunger/spring in the slide, and then remove the plunger lifting cams (replaced with the spacer). This allows you to set a trigger with take up to be very crisp (no over pull to activate the firing pin device), and drop at least a pound off the pull/break point).
Top Top