Quoted:
However, the buttstock wiggles a bit, not too much, but i am not sure, should i thread the buttstock in more? thanks |
so, which buttstock are we talking about. are we talking about the A2/A1 full buttstock or the adjustable stocks?
For the adjustable stocks, +1 on just tighting the tube until it holds the buffer pin then tightening the castle nut.....if the stock wiggles, well......thats something that I've noticed about adjustable stocks. Sometimes you get one that wiggles, something one that doesn't. I've seen guys put electrical black tape on the tube to stop the wiggle.
For the A1/A2 stocks....i've also that the same problem....for me the tube will only go so far, because there is a lip on the tube and by the time you have threaded the tube enough to hold the buffer pin, the lip is already up against the lower reciever. I've also had a A2 buttstock that wiggles from side to side, and my homemade fix-it up was to put some tape on the little nub on the buttstock. Either the little nub that goes under the dimple that is under the buffer tube is out of spec, or the nub is out of spec. I was too lazy to measue or buy another stock to determine which is at fault. But with the piece of tape covering the nub, it has stop wiggling and works for me.