Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Posted: 9/1/2004 12:58:59 PM EST
I recentnly purchased a WASR for a good price, however it only takes the single stack magazines. IIRC the Hi-cap's are nothing more then modified low-caps, how is this done? Pictures would make my life easier because I lack any mechanical ineptitude.
Link Posted: 9/1/2004 3:39:41 PM EST
Link Posted: 9/1/2004 4:50:12 PM EST
I was going to do one. However I sold my WASR to a friend so I could build an AK-74, less hassle that way. Basically just get a magazine, sketch out its out line and use either a file or dermal to SLOWLY file out the shape. Just keep checking the mag fit. Also remove all the internals of the gun so you don’t get shavings in them.

Jack
.
Link Posted: 9/3/2004 1:42:01 PM EST
[Last Edit: 9/3/2004 5:43:15 PM EST by notso]
I did that to my Maadi-MISR10. Just put in your US parts, and then mark how much you want to grind out the mag well (I used a dremel with aluminum oxide grinding wheels). I used and Ironwood Designs stock set and a Tapco G2 trigger group for the US parts.

This is the mag well when I was done. As yoou can see, Im not a master machinist either
Top Top