Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
Posted: 9/28/2004 9:38:59 PM EST
Is there a trick to getting it out of the bolt carrier? I haven't tried heat yet. Got a US one to replace it. On both of my kits they weeble and wobble but won't come out.
Link Posted: 9/29/2004 2:27:24 AM EST
sand off the paint around the end of the carrier until you can see where the piston is pinned at. Take a drill bit and drill off most the expanded head on one of the pin. use a punch to drive the pin out driving it from the side you drilled.
Link Posted: 9/29/2004 9:15:22 AM EST
I see the pin now. Thanks. Maybe I should just replace the mag followers instead of the piston for compliance parts.
Top Top