Quoted:
I saw your thread over on PM or maybe another forum - I got a kick out of some of the comments trying to knock your idea.
Hello,
that's true to the saying a picture can tell a thousand stories to which each story has a different ending
here is my shield that i use for the mill , i did post it on another site i'm on where a member were asking about how to control the chips .
i bought 3 cell phone antenna's that had the magnets for $3.00 at a garage sell ,
and i used 2 magnets so far one for a air supply line for the lathe to softly blow chips away from the workpiece and the other i used to make my chip shield for the mill , i used a faceshield for grinding metal , a piece of one inch aluminum
and a L ~ bracket that was in my misc tub . simple and does the job , another shield that you could use would be a helment shield for riding a motorcycle
i used that one first but like the taller faceshield better .