Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
BCM
User Panel

Posted: 1/1/2006 10:42:51 AM EDT
went to the range the other day and tried some englewood research ammo the results is not one ar but two with the barrel blocked! i fired a round and heard nothing so wile getting that one out my shooting partner (1st time to range) tried one in my m4 and neglected to tell me ! i found out while cleaning the guns bullet is stuck 2 inches from the end of my 16 inch barrel .  any ideas how to get it out steel rod just bent when i tried the last one was right at the breach and came out ...this one wont  im so pissed its  not right to spend 50 bucks on a box of ammo to have this shit happen
Link Posted: 1/1/2006 12:03:04 PM EDT
[#1]
Could you fire a blank to get it out?
Link Posted: 1/1/2006 12:06:05 PM EDT
[#2]
I have used a regular cleaning rod on Squibs.

Tap on the end of the rod with a hammer, or use a wood dowl


Link Posted: 1/1/2006 1:48:29 PM EDT
[#3]
Are you talking about Engle Ballistic Research subsonic ammo?
Link Posted: 1/1/2006 2:11:56 PM EDT
[#4]
thats the stuff
Link Posted: 1/1/2006 2:16:24 PM EDT
[#5]
Were you trying it out with a sound suppressor?
Link Posted: 1/2/2006 1:49:39 AM EDT
[#6]
yup m4-2000
Link Posted: 1/2/2006 2:06:16 AM EDT
[#7]
Link Posted: 1/14/2006 12:06:24 AM EDT
[#8]
Use a wooden dowl rod it wont mess up your threads like a steel or alum rod will!!

Use clp or WD-40(pour it into barrel from chamber side) then use hammer to tap dowl rod!!

If the dowl breaks it will be easy to clean out,then try again!!!!

Bob
Top Top