User Panel
User Panel
User Panel
|
Posted: 4/25/2013 8:51:16 AM EDT
[#1]
There are a bunch of posts on the czforum about this.
Basics are drive out the roll pin (holds in the front sight and the barrel bushing), push old sight out, fit the new sight. Once it fits all the way into the slot, take the drill bit and drill the slot needed for the pin, insert the roll pin. I just did mine a few months ago; my front sight already had the slot in it for the roll pin so I did not have to drill. Took me about 20 minutes of careful fitting to get it all the way in.
|
|
|
|
Posted: 4/25/2013 2:54:20 PM EDT
[#2]
I don't drill the front sight after I install it. I seat the sight, mark the contact point, then pull the sight and file the groove in the bottom to allow the roll pin to be installed. I find it much easier that way.
|
|
|
AR15.COM is the world's largest firearm community and is a gathering place for firearm enthusiasts of all types.
From hunters and military members, to competition shooters and general firearm enthusiasts, we welcome anyone who values and respects the way of the firearm.
Subscribe to our monthly Newsletter to receive firearm news, product discounts from your favorite Industry Partners, and more.
Copyright © 1996-2024 AR15.COM LLC. All Rights Reserved.
Any use of this content without express written consent is prohibited.
AR15.Com reserves the right to overwrite or replace any affiliate, commercial, or monetizable links, posted by users, with our own.
