User Panel
User Panel
User Panel
|
Posted: 12/29/2005 8:25:48 PM EDT
[#1]
I have not had this problem but I have seen where some just shave them down a bit.
|
|
|
|
Posted: 12/29/2005 9:05:03 PM EDT
[#2]
Any technique on how? Or grab a razor blade and go to town?
|
|
|
|
Posted: 12/30/2005 3:57:40 AM EDT
[#3]
Make sure that the front section of the handgaurd is fully seated in the front handgaurd cap. also, make sure that the two halves of the handgaurds are not warped and fit flush together.
Other than that there is no reason that they should not go into the delta ring. Sometimes it takes a little working with to get them fully seated. |
|
|
|
Posted: 12/30/2005 3:58:58 AM EDT
[#4]
Rather than a razor, I'd try using sandpaper.z
|
|
|
|
Posted: 12/30/2005 4:28:28 AM EDT
[#5]
also make sure that the channel in the rear of the handguards are seating over the barrel nut
|
|
|
|
Posted: 12/30/2005 4:33:19 AM EDT
[#6]
I had the same issue in the past with an old rifle. After sanding they fit. If the delta ring spring is real loose, it might make it appear as if they don't fit properly also, as they riing can pivot around.
|
|
|
AR15.COM is the world's largest firearm community and is a gathering place for firearm enthusiasts of all types.
From hunters and military members, to competition shooters and general firearm enthusiasts, we welcome anyone who values and respects the way of the firearm.
Subscribe to our monthly Newsletter to receive firearm news, product discounts from your favorite Industry Partners, and more.
Copyright © 1996-2024 AR15.COM LLC. All Rights Reserved.
Any use of this content without express written consent is prohibited.
AR15.Com reserves the right to overwrite or replace any affiliate, commercial, or monetizable links, posted by users, with our own.
