For the guys that often post, " where in the hell is the pictures".
PISTOL GRIP ASSEMBLY
PARTS: selector detent, selector detent spring, pistol grip, pistol grip screw, lock washer
TOOLS: Allen key or flat-blade screwdriver (depends on your screw type)
· Install detent, pointed end towards the selector, and the spring into the receiver from the
bottom.
· Carefully compress the spring with the grip and make sure spring fits into hole in grip.
· Check the function of the selector with the grip held in place; if too tight (unable to rotate)
you may need to either cut the spring, or clean out the hole in the grip.
· Once feel is acceptable, secure the grip in place with the screw and lock washer.
FUNCTION CHECK
· Verify selector is able to move from safe to fire and clicks in place. It should not move past
the 'safe' or 'fire' positions.
· With selector on 'safe', verify cocked hammer is not released when trigger is pressed.
· With selector on 'semi', verify hammer is released when trigger is pressed.
NOTE: Selector cannot be rotated to 'safe' unless hammer is cocked.
P.S. Next time, it's just easier to point him to the Information button up in the top right of the screen (it where I pulled all of this down.