Posted: 1/5/2014 4:07:44 AM EDT
|
Good morning,
Looking for a smith in the DC area. I would prefer to drop off/ pick up than to mail. ~2000 SA Milspec that was worked on about 10 years ago. Has a 3.5# trigger and runs fine. However, I wanted to have the internals looked at and checked over for reliability/ safety purposes. Perhaps have some parts replaced with higher end stuff. Not real comfortable with such a light trigger. Looking for someone who would be good for just basic work, not looking for any "mods" or custom work... Let me know if you know of anyone in the area.... Thanks and regards |
|
Yes. Dropped it off Tuesday. Will report.
Regards ETA He broke it down and critiqued the previous work. Showed me where the previous used a grinder/ dremmel on the sear parts instead of a stone. He also showed me how it failed a safety check every few attempts. I always performed safety checks, but this type of check is new to me... |