Posted: 2/5/2014 5:27:50 PM EDT
|
Hey all,
I just got my 80% lower and I am planning on finishing it with a drill press. I am hoping on getting it engraved on the side with a custom logo and text. It's anodized (won't do that again) and I've heard that's pretty hard to engrave without a laser. SO… does anyone know of anywhere that would be able to laser engrave a logo on an AR15 lower. I am hoping to finish it first than get it engraved, but if not I could always wait if need be. Feel free to shoot me an email at [email protected] Thanks ahead of time, Drew |
|
You are looking for these guys.
http://identmarking.com/ They are doing the SBR engraving on my lower. They come HIGHLY recommended by many other guys that I trust on another forum. The armorer at my LGS is also doing an SBR build, and is sending his lower there. Also, they can engrave a completed lower without any type of transfer. According to the ATF, the work is considered a repair, which does not require a transfer or FFL to ship. Just put it in a box, ship it to them with signature requested, and when it's done, they ship it back the same way. Feel free to give them a call, they are very helpful on the phone (I called to discuss placement of my trust info because I have a billet lower with an integrated triggerguard). HTH, exx |
|
Quoted:
in Lino Lakes, MN? Did you have to do any transfer stuff out of state? Another endorsement for Orion Arms. I sent my SBR lower to them for simple word engraving and it looks like factory markings. They do custom logos too. My engraving cost about $60 and I assume a custom logo would be more, but it's worth it for the quality they do. I couldn't find anyone in WI either. Doesn't require anything special to ship it to them since they are a FFL. Just toss the receiver in a box, and ship it UPS to the address they have on their site. They engrave it, and ship it back to your house in a few weeks. |
|
Quoted:
You are looking for these guys. http://identmarking.com/ They are doing the SBR engraving on my lower. They come HIGHLY recommended by many other guys that I trust on another forum. The armorer at my LGS is also doing an SBR build, and is sending his lower there. Also, they can engrave a completed lower without any type of transfer. According to the ATF, the work is considered a repair, which does not require a transfer or FFL to ship. Just put it in a box, ship it to them with signature requested, and when it's done, they ship it back the same way. Feel free to give them a call, they are very helpful on the phone (I called to discuss placement of my trust info because I have a billet lower with an integrated triggerguard). HTH, exx I used Indent before, they do good work |