Warning

 

Close
Confirm Action

Are you sure you wish to do this?

Cancel Confirm
4411 Online
bravocompany bravocompany bravocompany
brownells brownells
tnvc tnvc tnvc
AR15.COM
bravocompany
My Account
bravocompany bravocompany bravocompany
brownells brownells
tnvc tnvc tnvc
JRH
skd
fightlite
Guns
RS
springfield
vortex
palmetto
Holosun
cz
silencerShop
colt
GS
geissele
aim
primaryArms
magpul
brownells
OSIGHT
DFC
bravocompany
midwest
4411 Online
brownells
DFC
GS
RS
colt
magpul
silencerShop
primaryArms
fightlite
vortex
bravocompany
skd
Guns
aim
cz
OSIGHT
midwest
springfield
geissele
JRH
Holosun
palmetto
Armory Sponsor
Site News Could You Have Stopped This? Vegas Shooting Analysis with Attorneys on Retainer
Sponsor News Introducing TNVC's NEW and Exclusive Filmed SuperGain (FSG) and Chimera Panoramic Goggle Giveaway!
9/3/2008 6:34:36 AM EDT
Picked up my GSG last night.  I'm installing a buffer and screw kit right away, and want to be sure the gun is tight before firing.

Are people detail stripping the bolt to Loctite the screws shown in jackal2001's pic below?
9/3/2008 8:26:42 AM EDT
[#1]
You don't need to take it down any further than that.  I would take those screws out one-by-one and locktite them back in there.  Locktite the ones on the outer breech housing shell as well.
9/3/2008 1:55:56 PM EDT
[#2]
OK, those are the self-tappers that cause problems when removed too often, right?

Also, should I use the Loctite wet or dunk and dry?  I've always used it wet.
Armory Sponsor
Faxxon
LAPG
cmmg
RS
brownells
gray
THBRD
LAPG
bravocompany
fightlite
colt
springfield
ar15com
SAS
palmetto
CA
primaryArms
Pro2A
silencerShop
geissele
ar15com
blackhills