Armory Sponsor
Posted: 1/2/2010 5:10:20 PM EDT
| Well after seeing one advertised I was very excited I thought it would be the cats ass on my FS2000's tri rail. However after purchasing and trying to get it on, it doesnt fit! The grip has these two..."wings" on each side toward the front that dont allow it to go on. As is its a tight fight on my AR. So now Im left debating if I should take a dremel to it and possibly ruin it to try to make it fit, or re-sell it and keep looking for a new fore grip. Thoughts? |
|
Lots of people are finding they need to dremel it to get it to fit with their accessories, rails, etc. I had to file down one of the wings and that little shelf on the left side in order to close the lever on my LT606 light holder.
I don't think you can ruin it by sanding just enough to make it work. I used a bench grinder and never felt I was endangering it's structural strength. I'm pretty sure if you sand it, make it fit, and don't like it, there is someone who will buy it, especially for $15-20. That's what I plan to do with it if I don't like it. I haven't shot with it yet to determine if it's a keeper. I'll probably give it to a friend instead of selling it... |
Armory Sponsor