Armory Sponsor
Posted: 3/16/2015 11:49:03 PM EDT
|
Sooo i finally picked up all my pistol cal suppressors and i own a saker 556 and 762.
Im looking to finish up most of my rifles now and im not sure what else to get. I have the following rifles. 556: 10.3in 14.5in 18in 308/762x39 ptr32 sbr ar10 ptr91 I figure i toss the saker 556 on the 18incher, and get a saker k for the sbr but im missing one more can in the 556 world... I am looking at the recce 5, M4sd II, or a specwar 556k.. I can move things around other then i want a saker on the 10.3 for obvious reasons. In the 308/762 world, i have my saker 762 on my ptr32 sbr, and generally speaking will stick with Sico on the ptr91 as i can get mounts in the right pitch past that im open i was looking at the Rsta but could go omega or thunderbeast etc. soo what do you recommend ? |
|
So after taking to ss about use cases for rifles etc
They sugessted 2x recce 5's for the 14.5 and 18 in host Rsta for the ar10 , and recce 7 for the ptr91 I mostly good on that based on what we talked about Just not sure I want the saker 556 on my sbr or go smaller with the saker k.. If I went with the saker k I'd prob move the saker 556 to the 18 in host |
RSTA on an AR-10:
18" Rainier Barrel, 15" Samson Evo rail. I also run it on a 300BLK AR-15 and remington 700 and a 308 Savage. It's been great so far. My only complaint really is the weight, but honestly, it's not like I'm running and gunning it, so I don't really mind too much. If I were buying a second 308 or larger silencer, I'd go light weight (Maybe the TB Ultra 7 or 9 or the new Sig 338 TI silencer or something). |
Here you go...
Samson was a true 15" rail and the fully seated RSTA clocks in right at 15.5". This is mounted with the flash hider, so no shims. If you run the muzzle break, you'll have a few shims for timing, so that would push the mount a little further out of the way. However, if the ID of your rail is 1.75", there is no way it would touch. I run the RSTA inside a KAC URX 4 on my 300BLK and it clears. I have also run it inside a Samson EVO rail. Both those rails are just over 1.5" ID (The KAC is like 1.52" and the Evo is 1.56 or something like that). As long as the rail is solid, I doubt you could flex it enough to hit the silencer. Here is the clearance on the URX 4, it's very close: 
|
Armory Sponsor