Dealer called and by Trident-9 paperwork just came in . My question is...do I need any kind of washer or anything to put a male three lug on? Just Rocksett? What kind of wrench should I use...there are no flats on the adapter?
Posted: 3/24/2011 10:23:21 AM EDT
[#1]
Most people seem to pin theirs on, from what I've seen. I would recommend that route personally. Just send it to Adco and have them pin it on.
Posted: 3/24/2011 12:42:40 PM EDT
[#2]
ADCO does good work. I went with an entire barrel with a three lug built in/on. but the screw on one should be fine - especially as ADCO should be able to advise you on concentricity.
Posted: 3/25/2011 1:55:38 PM EDT
[#3]
just use either rockset or other good high temp thread locker snug it dow tight and you be gtg.
Jeremy
Posted: 3/25/2011 7:47:42 PM EDT
[#4]
Quoted: just use either rockset or other good high temp thread locker snug it dow tight and you be gtg.
Jeremy
This is what I ended up doing...thanks.
Posted: 3/25/2011 9:47:42 PM EDT
[#5]
I just used some red loctite and a strap wrench. No washer...
. My question is...do I need any kind of washer or anything to put a male three lug on? Just Rocksett? What kind of wrench should I use...there are no flats on the adapter?