Warning

 

Close
Confirm Action

Are you sure you wish to do this?

Cancel Confirm
9789 Online
bravocompany bravocompany bravocompany
brownells brownells
tnvc tnvc tnvc
AR15.COM
bravocompany
My Account
bravocompany bravocompany bravocompany
brownells brownells
tnvc tnvc tnvc
colt
bravocompany
GS
OSIGHT
midwest
RS
DFC
cz
primaryArms
fightlite
Guns
geissele
JRH
magpul
springfield
aim
silencerShop
Holosun
brownells
palmetto
vortex
skd
9789 Online
cz
bravocompany
springfield
OSIGHT
geissele
DFC
Guns
JRH
vortex
primaryArms
fightlite
midwest
magpul
Holosun
colt
aim
silencerShop
RS
GS
palmetto
brownells
skd
Armory Sponsor
Sponsor News Introducing TNVC's NEW and Exclusive Filmed SuperGain (FSG) and Chimera Panoramic Goggle Giveaway!
Site News The People of Virginia VS Grabigial BanBerger | ARFCOM News
2/4/2010 4:19:36 PM EDT
I have a BCM 11.5" upper and it will host an M4-2000 once the paperwork comes back. My question is, is it crucial to send it off to ADCO or someone to check the threading for concentricity or is mounting the can and looking down the barrel from chamber to muzzle sufficient? I don't mind sending it off, but I don't want to disassemble my upper if I don't have to.
2/4/2010 4:43:03 PM EDT
[#1]
it should be fine.
2/4/2010 5:26:36 PM EDT
[#2]
Shouldn't be a problem. Just make sure you look down the tube before you put any rounds through the can. You shouldn't have any problems with BCM barrels. If it were a lower quality gun I would advise differently.
Armory Sponsor
colt
ar15com
silencerShop
cmmg
springfield
ar15com
geissele
CA
brownells
RS
Faxxon
palmetto
blackhills
bravocompany
fightlite
SAS
LAPG
ar15com
LAPG
Pro2A
gray
primaryArms