Armory Sponsor
Posted: 10/12/2012 3:13:41 PM EDT
| Hello, I wasn't 100 percent sure where this should go..... Anyways I recently purchased a Burris gen 3 fastfire to put on my Browning buckmark. To my dismay I found that it appears that the screws that came with the mount are smaller than the holes in the mount? They will not gain any tension when I attempted to screw them into the holes. I contacted Burris a couple of days ago but haven't heard back from them. Since it appears they aren't going to help I was wondering if anyone else had the same problem and/or any suggestions on how to get that mount to work. |
Armory Sponsor