Armory Sponsor
Posted: 7/13/2010 9:21:29 AM EDT
|
I have a 1993 traditions replica Walker
I emailed them to confirm the load since the manual only said 20-30 grains of 3F I got an answer back "55 grains of 2F" with a round ball any idea why they would sugess 2F vs there old manual from 1993 stating 3F any differences in pressures since there is more surface area with 3F.. I have a confirming letter into them, just wondering what you all think 
|
| I don't have a Walker... Yes, there will be greater pressure with the 3F. (That's what the theory says.) I've taken to shooting my 1860 Colt with 2F but in the past I used 3F. I didn't find much difference in recoil and POI between the two. I suspect when shooting 55 gr out of a pistol 2F might be more pleasant but I doubt you will have any issues shooting 3F. |
|
Quoted:
Quoted:
Traditions emailed back with 3f. couldnt get all 55 grains in the cylinder so I ended up with 50. and people wonder why these things blow up. The Dragoon was produced because of the problems seen with the fielded Colt Walker revolvers, namely, the Walker's large size, four and a half pounds, making it suitable only for use as a saddle-mounted revolver, the Walker's propensity for cylinders exploding on occasion when fired, and the Walker's habit of dropping the loading lever upon discharge, locking up the revolver action in the middle of combat. The Colt Dragoon Revolver had a comparatively shorter cylinder and held up to 50 grains of powder, whereas the Walker had used up to 60 grains of powder. The Dragoon Revolver had a shorter barrel at 7.5 inches (some later revolvers 8 inches) as compared to the 9 inches barrel on the Walker. A loading lever latch in front of the lever replaced the spring to keep the lever from dropping during recoil, thereby preventing jamming of the revolver. These variations made the Colt Dragoon Revolver 4 pounds two ounces. These changes also reduced the risks of the Colt Dragoon Revolver from exploding when fired, unlike the risk that had been demonstrated with the Walker revolvers. just pointing out the difference between the Dragoon and Walker. If it is needed I dont know, just putting out the info I have. later 
|
|
Quoted:
All of the Walker and first thru third model dragoons were intended to be used in pommel holsters. They were crew served handguns with the horse being an essential member of the crew.
The Dragoon was produced because of the problems seen with the fielded Colt Walker revolvers, namely, the Walker's large size, four and a half pounds, making it suitable only for use as a saddle-mounted revolver, |
Armory Sponsor