Armory Sponsor
Posted: 4/16/2017 8:48:34 PM EDT
| Are there any recommendations for an upgraded extractor for a factory bolt. I recently upgraded to a 16.5" Kidd lightweight barrel threaded for my suppressor that is still in NFA red tape jail. I'm having problems extracting unfired cheap Winchester bulk bullets. I'm guessing due to the tighter match chamber and poor quality control. Should I go with volquartsen, Kidd? Anyone else? I hope the $10 -$15 part will fix this due to having thousands of rounds of this lot of ammo and the frequent pest control needed at my wooded lot in the country. |
|
Either one will serve you well, I have the Volquartsen in mine.Â
If you're dealing with the original bolt you can always send it to CPC [url=http://www.ct-precision.com/]for his headspace and bolt work, he sells and installs an EDM tool steel extractor.   [/url] |
|
Thanks for all the comments. I think I'll try the volquartsen.
After re reading my post I just wanted to clarify in case it sounded bad. The poor quality control was meant at the ammo not the Kidd barrel. I love that barrel. It is right up there with the Anschutz 54 heavy barrel I used to have. I can't wait to get some more varieties of match ammo to see what it is capable of. I forgot how much I loved having a 22 that shot better than I can. If I miss now it's me no more excuses |
| I ended up getting the kidd extractor because it was a better deal. I couldn't be happier. It completely fixed my problems. I waited to post this to make sure it Kept working with all ammo I had. I wish I had the money for a complete kidd supergrade now. I am impressed with everything I have gotten from them. |
Armory Sponsor