Warning

 

Close
Confirm Action

Are you sure you wish to do this?

Cancel Confirm
9314 Online
bravocompany bravocompany bravocompany
brownells brownells
tnvc tnvc tnvc
AR15.COM
bravocompany
My Account
bravocompany bravocompany bravocompany
brownells brownells
tnvc tnvc tnvc
RS
primaryArms
aim
vortex
midwest
Guns
CA
springfield
GS
magpul
DFC
skd
cz
Holosun
bravocompany
brownells
colt
geissele
JRH
fightlite
palmetto
silencerShop
9314 Online
silencerShop
primaryArms
geissele
GS
RS
springfield
JRH
CA
DFC
Holosun
vortex
fightlite
skd
palmetto
Guns
midwest
bravocompany
aim
brownells
cz
magpul
colt
Armory Sponsor
Sponsor News Introducing TNVC's NEW and Exclusive Filmed SuperGain (FSG) and Chimera Panoramic Goggle Giveaway!
Site News The People of Virginia VS Grabigial BanBerger | ARFCOM News
6/23/2008 7:57:01 AM EDT
Just installed tech sight on my new 10/22.

I haven't dug into the problem deeply (yet) but, after installing the rear sight, I can't pull the bolt back. My initial thougts are that the screws that attach the sight might be too long and the bolt is hitting the front screw.

Anyone have any thoughts or similar problem.

If I am doing something NOOB, don't hesitate to mention.

Thanks,

Falafull
6/23/2008 8:18:26 AM EDT
[#1]
Loosen the screw, and see if the bolt can slide back.  You might need to file a tiny bit off the bottom of the screw so that it doesn't contact the bolt when fully screwed in.
6/24/2008 12:49:12 AM EDT
[#2]
I had the same problem with a scope mount I installed, it turned out to be the screw was too long like you suggested. It was a simple fix of filing the screw in question shorter for the bolt to clear.
6/25/2008 8:14:39 AM EDT
[#3]
Thanks!
Armory Sponsor
gray
ar15com
ar15com
LAPG
LAPG
SAS
silencerShop
springfield
CA
geissele
RS
Pro2A
ar15com
bravocompany
Faxxon
cmmg
THBRD
primaryArms
blackhills
palmetto
fightlite
brownells