Armory Sponsor
Posted: 9/16/2016 12:16:09 AM EDT
|
Judging by where the shell latch is on the right side of the pic, is it bent? Rounds will not come out of the magazine tube.
http://imgur.com/R6IPArK |
|
Quoted:
So is the end of the latch bent? I can physically push it with my finger and the shells will come out but whatever is supposed to do it mechanically is failing to do so The only way for the shells to come out without working the action is by pressing that latch to the side. OR Is it not feeding when you work the action? ETA: Just saw your response above... Did you disassemble it or did it come like that from the factory? |
| I pushed that thing that catches the shells and carries them to the bolt/chamber down just to show an idea of where the shell latch is and how close it is to the primer. I know it has to be pushed to the right to release the shells. My problem is it's not being pushed to the right. It just stays in that one spot and won't allow any shells to exit. Yes it's been disassembled but in this pic it's fully reassembled |
|
Quoted:
Latch will move of I use my finger to move it. But will not move while cycling the action Does it move a little (but not far enough for a shell to come out) --- or does it not move at all when you open the action ? Have your replace the forearm? Do you have a side saddle or any other aftermarket part on the gun? |
| I have stripped this thing down 10 times and can't find the issue other than that latch being all the way over like that. Can't see any debris behind it and it will go flush against the side if I push it but only if I push it. Other pics of the latch I've see it was no where near the primer like this one is and more towards the edge |
Now that I can see the picture it is easy to tell that the left shell latch is broken and needs to be replaced. Part # 55 on this schematic |
Armory Sponsor