Warning

 

Close
Confirm Action

Are you sure you wish to do this?

Cancel Confirm
AR15.COM
12/18/2011 8:58:16 PM EDT
I took my gun out for it's first 50 rounds... at least since I've owned it.  It's a S.A. Compact.  It seemed to have a lot of powder residue for just 50 rounds when I brought it back home to clean.  Does .45 just leave a dirtier gun than 9mm?  Is there something off with the timing of the barrel?  Am I just being paranoid?  

Thanks
12/18/2011 8:59:13 PM EDT
[#1]
You're probably burning about 30% to 50% more powder...
12/18/2011 9:25:25 PM EDT
[#2]
let me add that my recoil plug has a key that fits in a notch on the slide.  Before I was shooting it was free moving could take it in and out without force, but after shooting it seems to have wedged itself or something.  I have to apply force to remove it from the slide.  I was also having failure to go into battery on a few rounds so maybe that's just due to recoil spring being weak.
12/19/2011 3:20:39 AM EDT
[#3]
type of powder has a lot to due with how clean the gun is after 50 rounds.

I can shoot 500 rounds of univ clays vs about 50 rounds of titegroup and the gun looks the same in "clean" dept.
12/19/2011 8:02:14 AM EDT
[#4]
Oh, well I guess I should add I was shooting PMC factory ammo.  I also noticed the barrel link pin fell out while I was cleaning.  From all my previous handling this never happened, I don't think this is normal.  There is also damage on the front of the barrel link but it was like that when I put it together... but probably still an indication something isn't right.
12/19/2011 9:55:34 AM EDT
[#5]
Quoted:
Oh, well I guess I should add I was shooting PMC factory ammo.  I also noticed the barrel link pin fell out while I was cleaning.  From all my previous handling this never happened, I don't think this is normal.  There is also damage on the front of the barrel link but it was like that when I put it together... but probably still an indication something isn't right.


Most likely the link damaged was caused by the link bumping into the back of the guide rod.   Some guide rods have a bevel to avoid this contact.   It's a simple enough modification to make if yours doesn't have the bevel already.