Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
BCM
User Panel

Site Notices
Posted: 10/22/2016 11:05:34 PM EDT
Well, I've owned an alloy Grade IV from C&S, sold it off and recently picked up a MKIII two tone on trade. Who can do a good sight install, remove the magazine disconnect and put on a better safety in less than a year?
Link Posted: 10/22/2016 11:12:39 PM EDT
[#1]
Try Novak.
I don't think it would be a year, but it may be a couple months.
Thats not much work so you should contact them for a turnaround time.
Link Posted: 10/22/2016 11:42:52 PM EDT
[#2]
Robar?
Link Posted: 10/23/2016 12:57:23 AM EDT
[#3]
Link Posted: 10/24/2016 4:18:04 PM EDT
[#4]
These guys, they did work on 4 different HiPowers for me, quality work, did not take more than 3-4 months on any project including all those you described.

APW Cogan
Link Posted: 10/26/2016 10:49:07 PM EDT
[#6]
I don't know his lead time but talk to Jim Garthwaite and find out.  Great guy and a HP artist.  Take a look at his replacement trigger too.
Link Posted: 10/29/2016 7:43:30 PM EDT
[#7]
Well the slide is off to Novack's for a quick turn around sight install. I'll put in the C&S Wide Trigger myself. After it's been shot a bit, I'll figure out what I want done to the gun.
Link Posted: 10/30/2016 7:46:28 AM EDT
[#8]
Discussion ForumsJump to Quoted PostQuote History
Quoted:
Well the slide is off to Novack's for a quick turn around sight install. I'll put in the C&S Wide Trigger myself. After it's been shot a bit, I'll figure out what I want done to the gun.
View Quote

About a 7-10 day turnaround with Novak sights . They've done all my BHP & 1911 work for over 30 years. Top notch company. Plus, replaced all my Tupperware guns sights (Glocks) while I waited at the counter.  
Top Top