Posted: 1/5/2015 10:33:44 PM EDT
|
Not worth the money IMHO I will be returning it.
OEM trigger pull - 7.5 +p striker spring with OEM trigger springs - 8.25lbs and a noticably louder strike PRP trigger spring kit and OEM striker spring - 9.5lbs, as many other people have had issues with, I have had light primer strikes with hard primers so I do not want to go below the strength of an OEM striker spring. All done with Lyman trigger pull gauge |
|
Quoted:
My XDs trigger measured 6 lbs pre and post recall. I don't see a need to replace the springs in mine. YMMV You may have a few more rounds through yours, I bought a post recall model and only have about 600 rounds through it. I know my xdm trigger smoothed out and is really nice after 1500 or so rounds. I always have people ask me if I have had a trigger job done and say nope, just a few thousand rounds. I was just hoping the PRP kit would lighten it by 1-2lbs. |
| I had one of the very first released XDs 45's. The factory trigger was around 8.5lbs after break in, after I installed the PRP spring kit it has been at 4.75lbs, that was almost two years ago. I for one think the kit is well worth it, but it sounds like the newer guns are coming with lighter springs from the factory. |
|
Quoted:
I had one of the very first released XDs 45's. The factory trigger was around 8.5lbs after break in, after I installed the PRP spring kit it has been at 4.75lbs, that was almost two years ago. I for one think the kit is well worth it, but it sounds like the newer guns are coming with lighter springs from the factory. I purchased mine over summer and it definitely was around the 8-9 pound range. |
|
Quoted:
Yes, not sure why. I re-installed the original springs and it went back to the original pull. I did not install a new sear like some of the other guys. Quoted:
Quoted:
Op your saying the kit made your trigger heavier? Yes, not sure why. I re-installed the original springs and it went back to the original pull. I did not install a new sear like some of the other guys. Weird I would call them I have read in other places their customer service is really good For what it's worth I was looking here because I ordered it myself received it last night and installed it. I didn't install the striker spring cuz heard possible light strikes. I had already polished the internals before installing to smooth it out. Even without the striker spring made trigger a lot lighter and a bit smother. It definitely gets my things up. I would call them I bet they will take care of you. Oh and I Just put the spring kit in I didn't buy the one with the sear |